5500a calibrator manual






















changes more than 5 °C. (See “Zeroing the Calibrator” in Chapter 4 of the A Operator Manual.) Also see additional specifications later in this chapter for information on extended specifications for ac voltage and current. The dimensional outline for the A Calibrator is shown in Figure A. POWER I O 0 ENTER M k m VHz FIELD EDIT +/ F. Page Wave Generator Calibration A Service Manual Note The Calibrator Mainframe will warn when the entered value is out of bounds. If this warning occurs recheck the setup and carefully re-enter the reading insuring proper multiplier (i.e., m, u, n, p). A Multi-Product Calibrator Operator Manual December , Rev, 7/06 © - Fluke Corporation. All rights reserved. Printed in U.S.A.


Page Wave Generator Calibration A Service Manual Note The Calibrator Mainframe will warn when the entered value is out of bounds. If this warning occurs recheck the setup and carefully re-enter the reading insuring proper multiplier (i.e., m, u, n, p). Description. A full-functioned calibrator that covers a wide range of common workload. The A Multi-Product Calibrator replaces the A and addresses common workload items like and digit digital multimeters and more. It comes with internal and external protection features that enable you to transport it easily and perform onsite or. A Multi-Product Calibrator Operator Manual December , Rev, 7/06 © - Fluke Corporation. All rights reserved. Printed in U.S.A.


A Service Manual. Calibration Constants Report, Spreadsheet Format ACTIVE=,0,STORED=,0,OLD=,0 VDAC_Z1, E+03, VDAC_Z2, E+03, VDAC_RATIO, E+03, VDAC_G, 5. 2 CALIBRATION SWITCH Used to write enable/disable nonvolatile memory that stores calibration constants. 3 SERIAL 2 TO UUT Connector used for transmitting/receiving serial data between the A and a Unit Under Test (UUT). 4 SERIAL 1 FROM HOST Connector used for remote control of the A with a host, printer, or terminal. Specifications for the standard A are provided at the fluke a calibrator manual of this chapter. Fluke a calibrator manual 95 V to V, its output is a square wave-like signal that alternates between the negative peak and the positive peak, with the centeriine at -1 0 V.

0コメント

  • 1000 / 1000