Install backup exec remote agent manually 2012

 · PM. Hi After updating remote agent manually,you can configure the publishing manually by going to remote agent utility,click on publishing and then enter the fully qualified name of media server and enter user name and password and that Estimated Reading Time: 4 mins.  · I have attempted to install it for testing, kept getting installation errors over and over, hence gave up. However, if you setup this server as a VM, you can perform a Non GRT backup and restore it successfully. Edit. You could still use the BE remote agent and try to backup data. I am not sure if you want to achieve DR capability. To uninstall the Remote Agent from a bit computer: \Program Files\Symantec\Backup Exec\Agents\RAWS To uninstall the Remote Agent from a bit computer: \Program Files\Symantec\Backup Exec\Agents\RAWSX Open a command prompt, and then type the drive letter that you mapped in step 1. Run the following command.

Backup Exec: BE - Failed to update a remote agent Hi After updating remote agent manually,you can configure the publishing manually by going to remote agent utility,click on publishing and then enter the fully qualified name of media server and enter user name and password and that server should be listed in back up restore console. To check if the Agent for Windows was installed: Go to the Windows services console (Start - Run - www.doorway.ru), and see if the Backup Exec Remote Agent for Windows service is present and started. An SSL trust will need to be established after a manual installation of the Agent for Windows. This is explained in the article below. Open a command prompt, and then type the drive letter that you mapped in step 1. Run the following command: To uninstall the Remote Agent from a bit computer: www.doorway.ru /RANT /S: u. The /S: parameter is used to run the operation in silent mode, without the benefit of a user interface. The -u parameter specifies an uninstall operation.

Backup Exec remote agent can be installed manually on a windows server as well. Lets check it. On Backup Exec media serve Go to C:\Program Files\Veritas\Backup Exec\Agents copy folder RAWSx64 / RAWS32 on the remote server. Now post copying the RAWS folder you can run the setup file. The installation window pops up click Next. Choose Local Install. Chapter 1 Introducing Backup Exec Special considerations for installing Backup Exec to remote prompt to install the Agent for Windows on a remote. 1. Install the remote agent manually (Local Installation) 2. Run the remote installation wizard from the Backup Exec server. This will say that the server already has the agent, and that all it needs to do is push updates to the client. hit yes. Now BE will have the server in the Favorites list. I've been using Backup Exec on Windows Server for over a year. No issues.